HomeDG16 General Discussion

Talk about anything related to Tajima DG16 by Pulse here

Jump stitches going from PXF to DST Messages in this topic - RSS

LissaBakke
LissaBakke
Posts: 3


8/4/2022
LissaBakke
LissaBakke
Posts: 3
I am getting a lot of jump stitches crossing over my designs when I convert them from PXF to DST. The same issue happens when I receive a DST file from my clients. How do I stop this from happening whenever I use a DST file? My Jump Convert is set to 3 and A. I'm not sure exactly how this setting works, but would it help to set this to B? Attached are a PXF file and the DST file that was created from the PXF file.

0 link






Powered by Jitbit Forum 8.3.7.0 © 2006-2013 Jitbit Software