https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx Tajima DG by Pulse Community - DG16 General Discussion - Jump stitches going from PXF to DST - Messages en-us http://blogs.law.harvard.edu/tech/rss Jitbit AspNetForum Wed, 10 Aug 2022 14:16:24 GMT Wed, 10 Aug 2022 14:16:24 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx Sorry, i should have looked at those before I responded.

Are your letters digitized segments or text segments?

You probably already know that trims are turned on in different places for each of those.
Since you don't show the trims on you PXF I cannot tell if you have them on correctly.
if they are turned on correctly you should see the scissors on each letter in the pxf as shown in this image.
those should carry thru to your DST.
]]> Wed, 10 Aug 2022 14:16:24 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx
You can also turn on and play with the quality control settings which will break up the long stitches and prevent this. Using quality control can have adverse effects in the appearance of the designs since it places additional stitches in between the offending long stitches. In the case of a wide satin, this will leave a row of stitches in the middle of the satin changing how it appears to some extent, but solves the jumps issues.

There are quite a few options in the Quality Control setting that give you some control of how these extra stitch get added to split the long stitches. It will require some playing to determine what works best for you.
edited by ChenilleGuy2 on 8/10/2022
edited by ChenilleGuy2 on 8/10/2022]]> Wed, 10 Aug 2022 13:52:50 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx I typically do not use this and use Save As and change format to whatever i need it to be.

if you have a lot of jumps in the output, this is typically because you have satin stitches in the design that are wider than the machine type you are outputting excepts to run well. You can check this in your design and if you find them, try changing them to fill stitch types or narrow them to a more proper width for the satin stitch type.]]> Wed, 10 Aug 2022 13:43:49 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx Fri, 05 Aug 2022 20:10:20 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx Fri, 05 Aug 2022 19:06:27 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx edited by WrightCreationsPA on 8/5/2022
edited by WrightCreationsPA on 8/5/2022]]> Fri, 05 Aug 2022 18:58:11 GMT https://dgcommunity.pulsemicro.com/topic2250-jump-stitches-going-from-pxf-to-dst.aspx Thu, 04 Aug 2022 20:08:13 GMT