Get assistance from your peers with any PulseCloud issues you may be experiencing
overlap in complex fill
|
mac ryan Posts: 12
2/5/2024
|
pulse 15.1.73.6300 maestro..
in sequence view nr 10, once complex fill , density profile/ anlonge middle, you ca adjust overlap linesin quality control. but the lines don't look fine in 3D view, also in embroiderie.
when density profile/ along edge inside 0.6 the lines dissappaers but the overlap is also gone.I can't change this because overlap is light gray.How tto change this.
see file mentl2 and meltl2test.pxf
|
|
|
0
link
|
|
Tajima Software Administrator Posts: 493
2/6/2024
|
Please see the reply from our support team:
If we are talking about a complex fill with crossing stitch angles, then it could be done by copy/pasting the shape and fill each one of the complex fill segments in opposing angles.
Make sure that the Start and End beads are positioned correctly so that the stitches travel according to your expectations.
In case you want the very first stitches to start in the middle, then you an insert Run stitches in the desired position.
|
|
|
+1
link
|