Talk about anything related to Tajima DG16 by Pulse here
Cross-Hatch Fill Start/Stop
|
TheFinishingTouch Posts: 4
1/23/2024
|
I hope I'm doing something wrong. When I have a design I wish to put on fleece or a beanie, etc., I like to create a knockdown stitch to hold the pile/fluff down. I create a BOUNDARY around the design as an object (not a "shape"), use a cross-hatch or a run stitch or even artwork as the border and then do a cross-hatch fill to create the knockdown stitching. My problem is... I cannot get the fill to sew from center out. Even if I try to move the start & stop beads, all they do is orbit the edge of the boundary. I'm unable to move them into the center of the knockdown field. How do I get the knockdown to sew center out instead of spiraling into the center from the outer edge? The same "problem" exists when I use a programmed fill (ie. 204) at a density of 10 spi. I am unable to have the start bead and stop bead anywhere inside the knockdown area. They will only sit on the outer edge of the segment. Is there a way to get the start/stop off of the edge?
edited by TheFinishingTouch on 1/23/2024
edited by TheFinishingTouch on 1/24/2024
|
|
|
0
link
|