Get assistance from your peers with any PulseCloud issues you may be experiencing
Long Tails
|
westy Posts: 1
6/13/2023
|
Hi everyone! I have checked my tension both top and bottom. I still keep getting long tails!! How do I fix this?? I have a TMEZ s1501C.
Thanks in advance!! Westy
|
|
|
0
link
|
|
TARA Design Posts: 5
6/21/2023
|
Try changing the setting in the machine (ATH) press F2, try to make the value lower
|
|
|
0
link
|
|
Sunbird Posts: 11
6/28/2023
|
Hi
The reason why you have long tails, is because the picker stays in the forward position to long while the machine is preparing to trim the thread. Tara is correct, you need to find the setting on your machine that controls the amount of time the picker stays in the forward position before it moves out again.
Good luck
OomJayJay
|
|
|
0
link
|
|
Luebbers Posts: 18
7/1/2023
|
The TMEZ doesn't have a picker. Neither does the TMBR. I get some long tails too, so I am wondering what is best to look into. Sometimes I get zero tails and then on the same job I get tails again.
|
|
|
0
link
|
|
absolutelygraphic@bromarprinting.com Posts: 1
7/27/2023
|
on my TMEX-1501 and TMFXll-1506 I adjust the upper tensioners on the threads rack, short tail, loosen, long tail tighten
hope it helps
|
|
|
0
link
|
|
liquidlogos Posts: 2
7/31/2023
|
Check you bobbin case make sure its clean under the presure plate. fiber builds and creates a wider gap
|
|
|
0
link
|