HomeDG16 General Discussion

Talk about anything related to Tajima DG16 by Pulse here

Lock Stitches Messages in this topic - RSS

DancingBayLLC
DancingBayLLC
Posts: 14


12/29/2022
DancingBayLLC
DancingBayLLC
Posts: 14
Of the choices of lock stitches, which provides the least noticable lock and is this the same for start and stop locks?
0 link
Tajima Software
Tajima Software
Administrator
Posts: 471


1/5/2023
Tajima Software
Tajima Software
Administrator
Posts: 471
Good morning,

Here’s the recommendation from our digitizing expert:

The selection of least noticeable lock stitches at the start and at the end of a segment depends very much on the type of segment you are dealing with.

Satin segments:
Basic lock stitch at the start bead position of a segment. Recommended to set “Start lock inside” with a 2mm value
Line lock stitches at the end bead of the segment.

Complex Fill segments:
Basic lock stitch at the start bead position of a segment. Recommended to set “Start lock inside” with a 2mm to 3mm value
Line lock stitches at the end bead of the segment.

Run Stitch segments:
Line lock stitch at the start bead
Line lock stitch at the end bead
Make sure that start bead and end bead are at different locations
+1 link






Powered by Jitbit Forum 8.3.7.0 © 2006-2013 Jitbit Software