HomeDG15 General Discussion

Talk about anything related to Tajima DG15 by Pulse here

name stacking in DG15 Messages in this topic - RSS

niksab
niksab
Posts: 1


7/14/2017
niksab
niksab
Posts: 1
Could someone please list the steps to stacking names in the same color using DG15? Not different colors. Thanks!
0 link
hssportsplus
hssportsplus
Posts: 1


4/26/2018
hssportsplus
hssportsplus
Posts: 1
I would like to know how to do this as well
0 link
GraphicExtremes
GraphicExtremes
Posts: 1


4/26/2018
GraphicExtremes
GraphicExtremes
Posts: 1
I would like to know this also
0 link
pulse_keri
pulse_keri
Administrator
Posts: 75


4/30/2018
pulse_keri
pulse_keri
Administrator
Posts: 75
Here are steps on name stacking:
1. create one line of text
2. copy and paste that text to equal the number of names
3. Make each line a separate color
4. right click and modify each line of text
5. Setup the machine to stop between color changes

Thank you
Keri
0 link
pulse_keri
pulse_keri
Administrator
Posts: 75


5/2/2018
pulse_keri
pulse_keri
Administrator
Posts: 75
Hi,

For name stacking without inserting color changes, follow the steps above and eliminate step 3.

Thank you

Keri
0 link
DancingBay
DancingBay
Posts: 3


7/5/2019
DancingBay
DancingBay
Posts: 3
I've created a stop file that I use when ever I want to stop at a specific place. The problem I found with adding a stop at the control panel is that I cannot control where it stops. I mainly use my stop file for cap back numbers and 3D foam. Essentially, the file is a single point run stitch with Needle up as the run style and the stop (instead of trim) as the command. I've attached the file and all are welcome to use it.

For number stacking for cap back, I created a file with about 10 numbers with stops in between. I set the properties (size, density, underlay, pull comp) the way I want them, flipped the design, and saved it. When I need number stacks, I just open that file, change the numbers, align center and top and my file is ready to send to the machine.

Attachments:
stop.PXF
0 link






Powered by Jitbit Forum 8.3.7.0 © 2006-2013 Jitbit Software